Overview:
The 96150 (30 foot) and 96216 (35 foot) is a complete central vacuum accessory package suitable for homes with significant hard floor and area rug surfaces. The hose is a two wire low volt hose that permits control of the vacuum from the hose handle, a 10.5" wide air turbine for carpeted surfaces, a floor brush for hard floor surfaces, and a complete compliment of tools for above the floor cleaning. This kit is not suitable for use with an electric power nozzle.
Features and Benefits:
The 1.375" inner diameter crush proof low voltage hose controls the on and off of the central vacuums through a two position switch in the hose handle.
The wall end contacts two pin jacks in the wall inlet and and creates a circuit though the switch permitting control of the vacuum.
The hose is crushproof, highly flexible, and light weight with a 30 foot hose weighing less than six pounds.
The easy grip hose handle rotates 360 degrees reducing strain on the wrist and forearm while extending the life of the hose.
A 10.5" wide air turbine nozzle which uses the power of the air stream to spin the agitator making it ideal for cleaning and grooming of carpeted surfaces.
The rotating agitator opens the carpet pile to expose embedded dirt for capture by the vacuum maintaining carpet appearance and extending carpet life.
The agitator of the turbine self adjusts to carpet conditions. Lowering to the low pile of area rugs and entry mats and lifting when it encounters plush carpet.
A 12" natural fill hard floor brush is included. Suitable for all hard floor surfaces including wood, tile, stone, laminate, vinyl, and polished concrete.
A ratchet telescopic wand measures 24" collapsed and extends at 1" intervals until is reaches 39" fully extended.
The wand is great on stairs where a shorter length is desired and sizes for a comfortable fit to the owner for general cleaning.
A 5" natural fill dusting tool ideal for all hard surfaces above the floor, baseboards, and window frames.
A 13" crevice nozzle is ideal for accessing tight spaces.
A 5" wide upholstery tool with nylon brush cleans and grooms upholstery and is ideal for vacuuming stair risers.
A tool clip permits the accessories to travel with the wand eliminating steps and time.
A mesh caddie bag collects all the tools and hangs on the same wall hanger as the hose.
Compatibility:
The 96150 (30 foot) and 96216 (35 foot) are compatible will all brands of central vacuum installed with pin jack inlets. To confirm compatibility with your central vacuum look for two small contacts projecting into the valve opening which the metal contacts on the hose end contact to allow control of the on off of the vacuum from the hose handle.
